ADC Gas Electric Steam AD-26 User Manual

Contents

ADC Gas Electric Steam AD-26 User Manual Manual pdf 47 page image

45N. PROGRAM LOCATION 11 (PL11)Time For Amount To StartLocation to be viewed/changed.Press “Perm Press” key.Upper display will read “tFAS” (TimeFor Amount To Start) and the lowerdisplay will read the actual amountprogrammed. If no change, press the“PERM PRESS” key, otherwise pressthe “HI TEMP” key or the “LOTEMP” key and then press the “PERMPRESS” key.Summary: The time for amount to start is programmable from 1 to 99 minutes.PL11tFASPerm Press4 HI TempPerm PressLO TempRefer to Section V for instructionson entering program locations.(Wait 3-Seconds)("Hold In" to Accelerate) ("Hold In" to Accelerate)PL12Proceed to next locationto be changedTo exit program mode,open program switchTime Decrease Time Increase