ACTi D52 Hardware Manual

Also see for D51: Installation guide User manual Hardware manual

ACTi D52 Hardware Manual Manual pdf 13 page image

www.acti.comHardware Manual13Installing the Camera on a SurfaceThis section describes the procedures in installing the camera directly on a flat surface, such asthe ceiling or the wall. For simplicity, most of the camera images used in the succeeding sectionswere taken using the camera model with heat sink; same procedures apply to the model withoutheat sink unless specified.Step 1: Unpack the CameraNOTE: To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retainthe plastic covering the dome cover until the camera is completely installed.1. Slide the mounting plate counter-clockwise to detach it from the camera.2. Remove the silicon bag.