Endura AZ series integral and remote transmitterCombustion oxygen monitor 5 ProgrammingIM/AZ20E–EN Rev. F 455.4.4 Device SetupUsed by Advanced users to set the instrument tag, specify thetype of probe, select cable length, set oxygen andtemperature ranges and to setup passwords for access at alllevels.Standard users have read-only privileges (except at theSecurity Setup level) and Read Only users have read-onlyprivileges for a reduced set of menu options.Parameter Comment / [Range] DefaultInstrument Tag Used to enter a tag (ID) of up to 20 characters in length forthe transmitter.Characters are selected from an alphanumeric list.The 'Instrument Tag' is not displayed in the Operatorpage(s) when a Display Mode of 3 x 9 is selected – seeSection 5.4.5, page 48.N / AProbe Type Selects the probe type to be used with the transmitter.AZ20 & Remote Tx AZ20 &Remote Tx*AZ20 & Integral TxAZ25 & Remote TxAZ30 & Integral TxAZ30 & Remote TxAZ35 & Remote TxAZ10 With FilterAZ10 No FilterCable Length The length in metres of the cable between the probe andthe remote transmitter. This length is used in the coldjunction measurement to compensate for the impedanceof the cable.[0 to 100 m]Note. Applicable only to remote transmitters.0 m*For marine application Exhaust Gas Recirculation (EGR) transmitters, the probe type is set to AZ10 NoFilter and cannot be changed.Table 5.9 Device Setup MenuMenuExit SelectDevice Setup
