Start-up 1479Start-upContents of this chapterThis chapter describes the start-up procedure of the drive.Start-up procedure1. Run setup of the drive control program according to the start-up instructions givenin Quick start-up guide for ACS880 primary control program (3AUA0000098062[English]) or in the firmware manual.• For drives with ABB sine filter, check that parameter 95.15 Special HWsettings is set to ABB sine filter. For other sine filters, see Sine filterhardware manual (3AXD50000016814 [English]).• For drives with ABB motors in explosive atmospheres, see also ACS880drives with ABB motors in explosive atmospheres (3AXD50000019585[English]).2. Validate the Safe torque off function according to the instructions given in chapterSafe torque off function on page 213.3. Validate the safety functions (options +Q923, +Q973 and Q982) as described inFSO-12 safety functions module user’s manual (3AXD50000015612 [English]),FSO-21 safety functions module user’s manual (3AXD50000015614 [English]) orFSPS-21 safety functions fieldbus module user’s manual (3AXD50000158638[English]).
