142 Technical dataInput power (DC) connectionVoltage (U1 ) ACS880-107-xxxxx-3: 513…566 V DC. This is indicated in the typedesignation label as typical input voltage level (566 V DC).ACS880-107-xxxxx-5: 513…707 V DC. This is indicated in the typedesignation label as typical input voltage levels (566/679/707 V DC).ACS880-107-xxxxx-7: 709…976 V DC. This is indicated in the typedesignation label as typical input voltage levels (742/849/976 V DC).Drive AC supply networktypeTN (grounded) and IT (ungrounded) systems, corner-grounded systems upto 600 V ACMotor (AC) connectionMotor types Asynchronous AC induction motors, permanent magnet synchronous motorsand AC induction servomotorsVoltage (U2 ) 3-phase symmetrical, Umax at field weakening point:ACS880-107-xxxxx-3: 0…400 V AC. The maximum value (400 V) is a typicaldrive input voltage level shown on the type designation label of the supplyunit corresponding to 380…415 V AC.ACS880-107-xxxxx-5: 0…400/480/500 V AC. The maximum values(400/480/500 V) are typical drive input voltage levels shown on the typedesignation label of the supply unit corresponding to 380…500 V AC.ACS880-107-xxxxx-7: 0…525/600/690 V AC. The maximum values(525/600/690 V) are typical drive input voltage levels shown on the typedesignation label of the supply unit corresponding to 525…690 V AC.Frequency (f2) 0…500 Hz, except0…120 Hz with sine output filters (option +E206)0…120 Hz for frames R1i…R5i with du/dt filters (option +E205)0…200 Hz for frames R6i and R7i with du/dt filters (option +E205)• For higher operational output frequencies, please contact your local ABBrepresentative.• Operation above 150 Hz may require type-specific derating. For moreinformation, contact your local ABB representative.Current See section Ratings (page 133).Switching frequency Frames R1i…R4i: 4.5 kHz (typical)Frames R5i…R8i: 3 kHz (typical)The switching frequency can vary per frame and voltage. For exact values,please contact your local ABB representative.Maximum recommendedmotor cable lengthFrames R1i…R2i: 150 m (492 ft)Frames R3i…R7i: 300 m (984 ft)Note: Tested with 100 m (328 ft) for EMC Category C3. See standards andmarkings information in Electrical planning instructions for ACS880multidrive cabinets and modules (3AUA0000102324 [English]).Frame R8i and multiples: 500 m (1640 ft)
