Section 6 Linking Device LD 800DN IP Address and MAC ID Configuration for LD 800DN9ARD000014-600 A 179IP Address and MAC ID Configuration for LD 800DNTo configure the IP address and MAC ID of LD 800DN by using the BridgeWayConfiguration tool, follow these steps:1. Launch the BridgeWay Configuration tool, by selectingStart > BridgeWay Configuration. The tool connect to the LD 800DNmodule and the BridgeWay Configuration user interface appearsas shown in Figure 64.2. In the Ethernet Configuration pane of the user interface, edit the IP Addressand the Subnet Mask fields to the desired values.3. In the DeviceNet Configuration pane of the user interface, edit the MACAddress field to set the desired node address/MAC ID.4. Click Download to Module from the Configuration menu, to initiatedownload of the new configuration to the LD 800DN linking device. Onclicking Download to Module, a dialog box with the following message isdisplayed:Downloading the configuration may cause the device toreset or active connections to be interrupted. Do you wishto continue?5. Click Yes if you wish to continue with the download.The LD 800DN is automatically reset after the IP Address and MAC IDconfiguration is downloaded from the BridgeWay Configuration tool.Apart from using the BridgeWay Configuration tool, other methods to set the IPAddress of the linking device are:• Setting IP Address using LD 800DN DIP Switch on page 179• Setting the IP Address through the Web Page on page 180Setting IP Address using LD 800DN DIP SwitchThere is an 8 position Dual In-line Package (DIP) switch on one end of theLD 800DN module. This DIP switch can be used to select a portion of the defaultIP Address.The value of the switch is assigned as the last octet of the IP Address when themodule powers up.
