User Manual of Digital Video Recorder137Menu > Configuration > Network2. Select the SNMP tab to enter the SNMP Settings interface.Figure 9. 18 SNMP Settings Interface3. Check the Enable SNMP checkbox to enable this feature.4. Configure the following SNMP settings:• Trap Address: IP Address of SNMP host.• Trap Port: Port of SNMP host.Figure 9. 19 Configure SNMP Settings5. Click the Apply button to save and exit the interface.Note: Before setting the SNMP, please download the SNMP software and manage to receive the deviceinformation via SNMP port. By setting the Trap Address, the DVR is allowed to send the alarm event andexception message to the surveillance center.9.2.5 Configuring NATPurpose:Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other networkdevices on the network and establish functional network services for data sharing, communications, etc. You canuse the UPnP™ function to enable the fast connection of the device to the WAN via a router without portmapping.Before you start:If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router towhich your device is connected. When the network working mode of the device is set as multi-address, theDefault Route of the device should be in the same network segment as that of the LAN IP address of the router.Steps:1. Enter the Network Settings interface.Menu > Configuration > Network2. Select the NAT tab to enter the UPnP™ settings interface.Available from A1 Security Cameraswww.a1securitycameras.com email: sales@a1securitycameras.com
