593D Systems, Inc.11 CUBEPRO MAINTENANCERESTORING ROUGHNESS TO THE PRINT PADIf the print pad is too smooth, the print material and glue may not adhere properly Using the sandpaper included in the toolkit, wipethe print pad diagonally across the print pad from corner to corner in both directions Rinse and thoroughly dry the print pad beforeinstalling it into the printerCLEANING THE JET WIPERIn addition to being a scraper for the print jets, the jet wiper assembly is also a refuse bin, collecting print material that has been primedfrom the print jets. As the jet wiper fills, it will need to be emptied regularly.1 With the print pad lowered, lift up the jet wiper off the thumbscrew rest2 Pull the jet wiper up and out to separate the mounting posts from the keyholeslots3 Remove the jet wiper assembly from the printer4 Remove the waste material from the jet wiper and then reinstall it in the CubePro Refer to the section titled Printer Setup formore information about installing the jet wiper Recycling information can be found in the section titled Cubify SustainabilityProgram
