3Com 4007 Release Note

Also see for 4007: Getting started guide Important notice Command reference guide Implementation guide Product guide

Contents

3Com 4007 Release Note Manual pdf 43 page image

Operating Considerations for Release 3.0.5 43n 3Com recommends that you enable the Trunk Control MessageProtocol (TCMP) on each end station of a trunk. If this protocol is notenabled on both end stations, TCMP cannot correctly validate trunkconfiguration rules. (29581)n When moving a staged module the trunking configuration is learnedfrom the fabric when automapping is used. (27113)Resilient Links n You can define resilient links only on switch fabric modules for portsthat are connected to GEN interface modules. However, if a resilientlink on a switch fabric module is connected to a GEN interfacemodule, and you replace that module with a Fast Ethernet Layer 2module, the switch fabric module incorrectly maintains the resilientlink. The resilient link does not work properly in this case. (26308)VLANs n The following bridge commands may take a few minutes to completewhen several VLANs are configured in the system:n bridge vlan moden bridge vlan definen bridge vlan removeTo minimize the delay, configure the VLANs in order of increasingVLAN ID (VID) and remove them in order of decreasing VID.