98 CHAPTER 4: U SING RF A UTO-T UNINGApply a RadioProfile to EachRadioWhen you create a MAP, a new radio (or radios, depending upon thetype of MAP created) are added into 3WXM. The radios use the defaultradio profile in 3WXM unless you create a new radio profile and apply itto each radio on the MAP.For more information about creating a radio profile, see “Create a RadioProfile and Map the Service Profile to It” on page 95. For moreinformation about creating a MAP, see “Create Your MAPs” on page 97.To apply a radio profile to a radio:1 In the Equipment area of the Organizer panel, expand the switch, thenexpand the MAP.2 Right-click on the radio and select Edit.3 Click the down arrow beside the Radio Profile box, and select the radioprofile.4 Click Finish.You have completed the necessary steps for configuring your RFenvironment.What’s Next? After you create your services (“Configuring Wireless Services” onpage 51) and following the instructions in this chapter to create your RFenvironment, you need to deploy your configuration and enablemonitoring. Optionally, you can improve your network monitoringoptions by modelling your floor and defining RF obstacles. For information about monitoring your network, see “Managing andMonitoring Your Network” on page 143. For information about enhancing RF Auto-Tuning with modelling tobetter define your site and improve monitoring options, see “Using RFAuto-Tuning with Modelling” on page 99.
