Menu
2gig Technologies 2GIG-NVR1 Installation Instructions Manual
            | |
2GIG-NVR1NETWORK VIDEO RECORDER (NVR)INSTALLATION INSTRUCTIONSContentsVerify that the package includes the following:• 1—2GIG Network Video Recorder Module (NVR)• 1—Plug-in Power Adapter (120VAC)• 1—3”CD• 1—Paper MounƟng Template Guide• 1— USB Mouse Controller• 1— 1 Terabyte Single Hard Disk Drive• 4—1-1/2" Phillips Screws and anchors• 4—1/4" Phillips Screws (for mounƟng hard drive to NVR cover)• 1—Removable Terminal Block (to connect alarm input/output)Figure 1. Network Video Recorder (NVR) ContentsInstallaƟon Tools Required• Phillips Screw Driver• Variable Speed Electric Drill• Level (for wall mounƟng of NVR module)Hard Drive Installation into NVR1. Remove the two screws on the boƩom of the Network Video Recorderhousing.Figure 2. Hard Disk Cover Removal2. Pry up the hard disk cover to expose wiring harness for harddisk connecƟon.3. Fix the hard disk to the hard disk cover using 4 1/4" Phillips screws (Providedwith NVR).Figure 3. Fixing Hard Disk to NVR Hard Disk CoverFigure 4. Placing Hard Disk/NVR cover into NVR case boƩom.4. Plug wiring harness to the hard drive terminals, then seat hard drive withcover down into NVR case.Figure 5. Plugging in Hard DriveAAAATOPUse holes marked with “A”when installing (1.4 inch length) screws.HARD DRIVE COVERHARD DRIVEWIRINGHARNESSPLUGCONNECTORHARD DRIVE |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved