2N BRI Lite User Manual

Also see for BRI Lite: User manual User manual User manual

Contents

2N BRI Lite User Manual Manual pdf 52 page image

2N TELEKOMUNIKACE a.s., www.2n.cz 52/1524.5 Basic Configuration - Step by StepThis subsection helps you put your BRI gateway in operation for the first time. Referto the paragraphs of for more detailed settings.S. 3Install the GSM gateway as instructed in . Remove the SIM cards orSubs. 2.2insert the PIN-disabled SIM cards before the first launch.Connect the GSM gateway to the Ethernet to be able to get connected to theaddress mentioned in , page from the web interface. If the default IPSubs. 4.1address of your gateway is not suitable for your Ethernet installation, change theIP address setting as follows:Disconnect the configuration terminal from the Ethernet.Disconnect the GSM gateway from the Ethernet.Get an Ethernet switch or an Ethernet crossed cable.With the crossed cable, interconnect the configuration terminal directlywith the GSM gateway.With the Ethernet switch, connect the configuration terminal and GSMgateway to the switch. We do not recommend you to connect any otherdevice.Change the IPv4 setting in your configuration terminal Ethernet settingsto, e.g.: IP=192.168.1.200, Net mask: 255.255.255.0Open your web browser and enter the IP address of your GSM gateway.Complete the factory login data.Change the required settings in theGateway configuration – Ethernetsection and save the changes into the GSM gateway.configurationConnect the GSM gateway to a standard Ethernet.Rechange the IP settings of the configuration terminal and reconnect theterminal to a standard Ethernet.Enter the new IP address of your GSM gateway to get connected to the webinterface.Set the current time and date for the GSM gateway in theGateway control – Datemenu./TimeCheck the for 'unlocked' in theLicence statusGateway control – Firmwaremenu. If the status is not unlocked, your GSM gateway is not equipped/Licencewith the proper licence (refer to ). Contact your dealer for the licenceSubs 4.2key.Set the correct PIN code value in theGateway configuration – Systemmenu to meet the PIN code of the SIM cards used.parametersSet new login data in the menu.Gateway configuration – Login configurationSwitch off the GSM gateway and insert the SIM cards. Connect the antenna tothe GSM gateway and switch the gateway on.