2N BRI Lite User Manual

Also see for BRI Lite: User manual User manual User manual

Contents

2N BRI Lite User Manual Manual pdf 120 page image

2N TELEKOMUNIKACE a.s., www.2n.cz 120/152System ControlAT&Gxx=RESET – Reset of GSM module No xxAT&Gxx=BLOCK – Block of GSM module No xxAT&Gxx=DOWN – Transfer of GSM module into the sleep modeAT&Gxx=ON – Transfer of GSM module into the idle modeISDN Settings%I00=xxx – pri1 protocol/mode:NT,TE,NT/S,NTNT (pri2 = TE,NT,SY,NT)For FW:2_03_15 only NT and NT/S (sync received from TE port)%I01=tei,mtp tei,mtp = 0..63,0 – .fixed tei,ptptei,mtp = 64,0 – .dynamic tei,ptptei,mtp = 64,1 – .fixed tei,mtp%I05=c1,c2,c3,c4 – cause codes for failed callsc1=dial timeout (TIMEOUT=120)c2=dis.prefix (REJECT=21)c3=req.mod/grp not ready (TEMPFAIL=41)c4=pref grps not ready (CONGEST=42)%I06=sack,proc,prog,ale – prog.elem (0=off,1..8) for isdn message%I07=opx/npx – list of old/new prefixes (max 47 chars)%I08=dial,ring,disc – dial (0 = off,1..255) dialtone to NT on empty SETUP, ring(0=off,1 ..255) ringtone to NT if no PROGRESS from PSTN1=EU (dial = constantly 425Hz,ring = 1000+4000msec 425Hz)2=CZ (dial = 300/300/600/1200msec 425Hz,ring = 1000+4000msec425Hz)3=HU (dial = constantly 425Hz,ring = 1000+4000msec 425Hz)4=GB (dial = constantly 425Hz,ring = 400+200+400+2000msec400+450Hz)disc(0=off,1..255) busy tone to NT interface on DISCONNEECT%I09=day,bits,enb – day (0=off,1..31) of clearing pri statctrl bits (b0=not defined, b1=not defined ,b2=subaddr–recv, b4=don't sendCONNECT_ACK in TE mode)enblock digits (0=overlap,1..20)%I11=xxx – dial for dig.call from pri1 (max 15 chars)%I21=xxx – dial for dig.call from pri2 (max 15 chars)%I127=msn – MSN number for TE mode%i28=pin (max 15chars) – PIN (password) for TE–>GSM callsGSM Settings