2N BRI Lite User Manual

Also see for BRI Lite: User manual User manual User manual

Contents

2N BRI Lite User Manual Manual pdf 118 page image

2N TELEKOMUNIKACE a.s., www.2n.cz 118/1526.3 List of Terminal AT CommandsBy default, all these commands start with AT. (Note: Some of the AT commands listedbelow may not be available in the current firmware versions.)Basic AT CommandsThe following command list is intended for all GSM gateways from that are based2Non the same SW architecture. Some of the AT commands may be inaccessible for theBRI gateways.A/ – repeat last command (without AT)I3 – copyright & firmwareI4 – serial number&FRES – factory defaults & reset&V – view active parameters (system)&VI – view active parameters (isdn)&V0 – view active parameters (common)&V# – view active parameters (modules 1..2)&VB - Overview of module assignment to groupsformat: B#=grpout0, grpin0# is the module numbergrpout, grpin - outgoing and incoming groups of module&V9 – view active parameters (inc. groups)&VALL – view all group parameters&VE – Overview of VOIP parameters&P – view pseudo params&N# – view network params (net 1..8)&NALL – view all network params&A – view autorouting table &R – view lcr–routing table &T – view bris + modules totals&TMOD – view all modules totals&G##=atcommand – send at command to module 0..1 (ended by OK from gsm)&G##=xtcommand – send at command to module 0..1 (ended by fromuser)&G##=cmd – cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON), (ATBAUD)&GALL=cmd – cmd for module 0..1 (RESET,BLOCK,OFF,DOWN,ON)&S – view aux, bris, modules status