Bosch Rexroth IndraDrive HMV01.1R-W0045 manuals
Rexroth IndraDrive HMV01.1R-W0045
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Introduction
- Basic Structure
- Drive System
- Tests and Certifications
- Important Directions for Use
- Areas of Use and Application
- Safety Instructions for Electric Drives and Controls
- Hazards by Improper Use
- General Information
- Protection Against Contact with Electrical Parts
- Protection Against Electric Shock by Protective Low Voltage (PELV)
- Protection Against Dangerous Movements
- Protection Against Magnetic and Electromagnetic Fields During Operation and Mounting
- Protection Against Contact with Hot Parts
- Battery Safety
- Disposal and Environmental Protection
- Component Designation
- Products
- Transport and Storage
- Mechanical Mounting
- Duty Capacity
- Mechanical Technical Data
- Installation Orientation
- Cooling and Cooling Units
- Mounting Cooling Units
- Electrical Installation
- Interference Elimination and EMC
- Rules for EMC-Correct Installation of Drives
- Optimal EMC Installation
- Electrical Data
- HMV01.1R-W0018, -W0045, -W0065
- Control Voltage
- Complete Connection Diagram
- Connecting Cables and Rails
- Control Voltage (+24 V, 0 V)
- PE Connection of Power Supply
- PE Connection, Power Supply Unit and Neighboring Device
- X1, Bus Module
- X2, RS232
- X3, Mains Connection
- X31, Connection for Messages
- X32, Mains Contactor Control, DC Bus Short Circuit, Braking Resistor Threshold
- X33, Acknowledge Messages of Internal Mains Contactor
- X14, Mains Voltage Synchronization
- Touch Guard
- Mounting
- Determination of Appropriate Power Supply Units
- DC Bus Peak Power
- Regenerated Energy
- Continuous Regenerated Power
- Peak Regenerated Power
- Connected Load of the Supply Unit
- Control Mains Contactor
- Without DC Bus Dynamic Brake
- Control via NC Controller
- Troubleshooting
- Checking and Repairing the Unit
- Replacing the Unit
- Diagnostic Display
- No Release of Hazardous Substances
- Recycling
- Service & Support
- Appendix
- Supply Unit to the Right of the Drive Controller
- Stacked Devices
- Clockwise Cable Routing
- Mains Connection
- Mains Supply Requirements
- HMV01.1E
- HMV01.1R
- Fusing with Direct Mains Supply
- Fault Current Protective Device
- Chronological Sequence when Switching ON and OFF
- When Switching Off
- Auxiliary Components
- Mains Filter HFD
- Index
Related products
Rexroth IndraDrive HMV01.1R-W0065Rexroth IndraDrive HMV01.1R-W0018Rexroth IndraDrive HMV01.1E-W0075Rexroth IndraDrive HMV01.1E-W0030Rexroth IndraDrive HMV01.1E-W0120REXROTH IndraDriveRexroth IndraDrive CRexroth IndraDrive MRexroth IndraDrive CSRexroth IndraDrive MiBosch categories
More Bosch categories