OHAUS Frontier FC5816 manuals

Frontier FC5816

Brand: OHAUS | Category: Laboratory Equipment

Frontier FC5816

Brand: OHAUS | Category: Laboratory Equipment

Table of contents

1. Table Of Contents
2. Table Of Contents
3. INTRODUCTION
4. S AFETY P RECAUTIONS
5. Measures for operational safety
6. INSTALLATION
7. S AFETY PRECAUTIONS DURING OPERATION AND WARRANTY
8. Loading angle rotors
9. Loading and overloading of rotors
10. Lid lock
11. Preselection of running time
12. Pre-selection of temperature (Only Refrigerated Models)
13. P ROGRAM
14. Recall of stored programs
15. The "STOP" key
16. SETTING
17. Signal turn on / off
18. Song selection for sound signal - end of run
19. MAINTENANCE
20. Cleaning and disinfection of the unit
21. Glass breakage
22. Description of the error message system
23. RECEIPT OF CENTRIFUGES TO REPAIR
24. TECHNICAL DATA
25. Centrifuge FC5718
26. Centrifuge FC5816
27. Centrifuge FC5816R
28. D RAWINGS AND DIMENSIONS
29. COMPLIANCE
30. APPENDIX
31. T ABLE 2: P ERMISSIBLE NET WEIGHT
32. T ABLE 3: L OWEST TEMPERATURES AT MAX . SPEED (O NLY R EFRIGERATED M ODELS )
33. T ABLE 4: M AX . SPEED AND RCF- VALUES FOR PERMISSIBLE ROTORS
34. T ABLE 5: A CCELERATION AND DECELERATION TIMES
35. T ABLE 6: E RROR MESSAGES
36. T ABLE 7: R ADIUS CORRECTION AND ADAPTER SPECIFICATIONS
37. T ABLE 8: R EDEMPTION FORM / D ECONTAMINATION CERTIFICATE

Frontier FC5816

Brand: OHAUS | Category: Laboratory Equipment

Frontier FC5816

Brand: OHAUS | Category: Laboratory Equipment

Frontier FC5816

Brand: OHAUS | Category: Laboratory Equipment

Table of contents

1. Table Of Contents
2. Table Of Contents
3. GETTING STARTED
4. SAFETY PRECAUTIONS
5. Exclude the following environmental influences
6. SERVICE FACILITIES
7. Deceleration times
8. Imbalance shut off data
9. Specifications
10. SERVICE INSTRUCTIONS
11. Frequency converter
12. Lid contact
13. SERVICE MENU
14. Submenu Duty cycle
15. Submenu Software status of the frequency converter
16. Submenu Setup of the temperature (for refrigerated units only)
17. Submenu Setup of the signal generator
18. Submenu Setup of the keypad tone
19. Submenu Setup volume of the signal generator
20. Submenu Check and calibration of the imbalance sensor
21. Submenu Indication of the imbalance value of the rotor
22. Submenu Indication of the revision number of the control panel
23. Submenu Adjustment of the operation mode
24. Submenu Adjustment/Correction of the imbalance cut off value
25. MOUNTING SUPPORT
26. Removing the housing and the lid gasket GLUED
27. Removing the lid and the hinges
28. Removing the hinges
29. Replacing the power board
30. Replacing the frequency converter
31. Checkup the imbalance sensor
32. Replacing the control board
33. Replacing the break resistor
34. Replacing the rotor sensor
35. Replacing the temperature sensor (FC5816R only)
36. Refrigeration system (FC5816R only)
37. TROUBLE SHOOTING
38. Description of the error message system
39. MAINTENANCE
40. Cleaning and disinfection of the unit
41. Glass breakage