Husqvarna 125 TC EU manuals
125 TC EU
Table of contents
- Table Of Contents
- Table Of Contents
- means of representation
- safety advice
- protective clothing
- important information
- view of vehicle
- View of vehicle, rear right (example)
- serial numbers
- clutch lever
- Map‑Select switch (250 TC EU)
- fuel tap
- Kick starter
- preparing for use
- preparing the vehicle for difficult riding conditions
- Preparations for riding on wet sand
- preparations for riding at high temperatures and low speeds
- Preparing for riding at low temperatures or in snow
- riding instructions
- starting off
- Stopping, parking
- Refueling
- service schedule
- Service work (as additional order)
- tuning the chassis
- Adjusting the high-speed compression damping of the shock absorber
- Measuring the sag of the unloaded rear wheel
- Checking the riding sag of the shock absorber
- Checking the basic setting of the fork
- Adjusting the compression damping of the fork
- Handlebar position
- service work on the chassis
- Loosening the fork protection
- Removing the fork protector x
- Removing the lower triple clamp x
- Installing the lower triple clamp x
- Checking the play of the steering head bearing
- bearing
- Installing the start number plate
- Installing the shock absorber x
- Removing the seat
- Removing the main silencer
- Removing the right side cover
- cleaning the chain
- checking the chain tension
- Checking the chain, rear sprocket, engine sprocket and chain guide
- Checking the routing of the throttle cable
- Checking the rubber grip
- Checking/correcting the fluid level of the hydraulic clutch
- brake system
- adding front brake fluid x
- checking the front brake linings
- Checking the free travel of foot brake lever
- Checking the rear brake fluid level
- checking the rear brake linings
- removing the front wheel x
- removing the rear wheel x
- checking the tire condition
- checking the tire air pressure
- cooling system
- checking the antifreeze and coolant level
- checking the coolant level
- refilling with coolant x
- tuning the engine
- Carburetor - idle
- Changing the ignition curve
- service work on the engine
- cleaning the motorcycle
- preparing for use after storage
- troubleshooting
- technical data
- Engine tightening torques
- TC EU
- Capacities
- Tires
- Shock absorber
- Chassis tightening torques
- Carburetor
- Carburetor tuning
- Carburetor tuning (250 TC EU)
- SUBSTANCES
- auxiliary substances
- STANDARDS
- INDEX