11 SERVICE WORK ON THE CHASSIS 53InfoWhen the adjusting screw is turned counterclockwise, the clutch levermoves away from the handlebar.When the adjusting screw is turned clockwise, the clutch lever movescloser to the handlebar.The range of adjustment is limited.Turn the adjusting screw by hand only, and do not apply any force.Do not make any adjustments while riding!B01898-10(250 TC EU)– Adjust the basic setting of the clutch lever to your hand size by turning adjustingscrew 1.InfoWhen the adjusting screw is turned counterclockwise, the clutch levermoves closer to the handlebar.When the adjusting screw is turned clockwise, the clutch lever movesaway from the handlebar.The range of adjustment is limited.Turn the adjusting screw by hand only, and do not apply any force.Do not make any adjustments while riding!11.48 Checking/correcting the fluid level of the hydraulic clutchInfoThe fluid level rises with increasing wear of the clutch lining discs.L00953-10(125 TC EU)– Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.– Remove screws 1.– Remove cover 2 with membrane 3.– Check the fluid level.Fluid level under top edge of container 4 mm (0.16 in)» If the level of the fluid does not meet specifications:– Correct the fluid level of the hydraulic clutch.Hydraulic oil (15) ( p. 100)– Position the cover with the membrane. Mount and tighten the screws.L01222-10(250 TC EU)– Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.– Remove screws 1.– Remove cover 2 with membrane 3.– Check the fluid level.Fluid level under top edge of container 4 mm (0.16 in)» If the level of the fluid does not meet specifications:– Correct the fluid level of the hydraulic clutch.Brake fluid DOT 4 / DOT 5.1 ( p. 100)– Position the cover with the membrane. Mount and tighten the screws.InfoWash off overflowed or spilled brake fluid immediately with water.
