red lion RAM-6021 Hardware And Installation Manual

Also see for RAM-6021: Quick start guide Software user's guide Quick start guide Hardware guide

Contents

red lion RAM-6021 Hardware And Installation Manual Manual pdf 13 page image

Wired Router Hardware & Installation Guide 12Removal Instructions:2.3 Ethernet CableIf you are connecting to the router via the Ethernet port, you will need a straight or crossover category 5 cable with two8‐pin RJ45 connectors on each end.To visually confirm that Ethernet cabling was done properly, check the LED indication on the Ethernet port located on thefront panel of the router. The Link LED should be on when the right cable is used.2.4 USB CableThis is an Ethernet‐over‐USB connection which behaves like an Ethernet connection. If you are connecting to the routervia the USB port, you will need a Type A plug to Type B plug USB cable for the mini Type B plug to Type A plug for the RAM‐6021 wired router In order for the USB connection to work, you need to install the Sixnet USB driver which is available atRed Lion website.Note: With firmware version 4.17 and later, standard Windows RNDIS drivers are used and no additional driver isrequired from Red Lion website. The unit is compatible with Windows 7/8 and other operating systems (OSX, Linux, etc).2.5 Serial CableThe router has all of its serial port pins enabled. If all the pins are enabled on the attached serial device, it is important toknow whether the device is using DTE or DCE as a communication mode.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

/ 15

Related manuals for red lion RAM-6021