red lion CUB2L8 Quick Start Manual

Also see for CUB2L8: Manual

red lion CUB2L8 Quick Start Manual Manual pdf 1 page image

 INTERNAL LITHIUM BATTERY PROVIDES UP TO 7 YEARS OFUNINTERRUPTED OPERATION FIELD CONNECTABLE FOR FRONT PANEL RESET, REMOTERESET, OR BOTH COUNT SPEEDS UP TO 5 KHz (High Speed Input) WIDE TEMPERATURE RANGE -25° TO +75°CDESCRIPTIONThe CUB2L8 counter is powered by an internal lithium battery, which willprovide up to 7 years of continuous operation. This counter has an 8-digit LCDdisplay with 0.30" (7.6 mm) high digits.This counter uses a CMOS LSI counter circuit chip, mounted on a gold-plated substrate and electrically connected by ultrasonic wire-bonding. Internalelectrical interface connections use elastomeric contacts to provide a gas-tight,corrosion resistant connection. Using the latest in micro-electronic assemblyand manufacturing techniques provides units with the reliability anddependability required for industrial service.The CUB2L8 is constructed of a rugged die-cast metal case with a clearviewing window.SPECIFICATIONS1. DISPLAY: 8-digit LCD, 0.30" (7.6 mm) high.2. POWER SOURCE: Internal 3.6 V lithium battery to provide up to 7 yearsof continuous operation. Battery life is dependent upon usage. Count andreset contacts which remain closed for long periods of time will reducebattery life.3. HIGH SPEED INPUT: 5 KHz from 3.6 V bi-polar output with a 50%duty cycle.4. LOW SPEED INPUT: 30 Hz from switch contact or open collectortransistor with a 50% duty cycle.5. REMOTE RESET: 15 msec min. pulse width (active low) from a 3.6 Vbi-polar output or an open collector transistor or a switch contact to ground.6. OPERATING TEMPERATURE RANGE: -25° to +75°C7. CONSTRUCTION: Rugged die-cast metal case with a clear viewingwindow. Panel gasket and mounting clips included with unit.8. WEIGHT: 5.1 oz. (145 g)ELECTRICAL CONNECTIONSThere are certain considerations that should be observed when running thecount and control signal wires. A length of wire can act like an antenna and thecloser it is to a source of electrical noise, the more it becomes susceptible tothat noise.There are a few rules that should be followed when running these wires.1. Never run count or control signal wires in the same conduit or raceway withAC power lines, conductors that feed motors, solenoids, SCR controls,heaters, etc.2. Signal wires within enclosures should be routed as far away as possible fromcontactors, control relays, transformers, and other electrically “noisy”components.3. When shielded wire is used, connect the shield to the common of the CUBunit, and leave the other end of the shield disconnected and insulated frommachine ground.4. Mount the CUB2L8 in a panel that is grounded to the machine frame.MODEL CUB2L8 - MINIATURE ELECTRONIC 8-DIGIT COUNTERDIMENSIONS & INSTALLATIONCounters should be mounted in a panel grounded to the machine frame.After cutting the panel opening, slide the panel gasket over the rear of thecounter body to the back of the bezel lip. Then slide counter through thepanel cut-out. Install mounting clips on each side of counter body withmounting screws. Make sure the side rails of the clips fit into the recessesin the side of the counter body so that the “Tang Ends” wedge between thepanel opening and body as the screws are tightened.DIMENSIONS: In inches (mm)GASKET.032 (0.8) THICKBATTERYCOVER TANGENDSMOUNTINGCLIPSMOUNTINGSCREWSEXISTING PANEL.05 TO .20 THICK(1.3 TO 5.1 THICK)PANEL CUT-OUT1.3 X 2.65(33 X 67.3).325(8.3)0.95(24.1)1.415(36)2.835(72)Warning: Lithium battery may explode if incinerated. Signal input voltageshould not exceed 3.0 VDC to prevent damage to the counter.ORDERING INFORMATIONMODEL NO. DESCRIPTION PART NUMBERSCUB2L8 CUB2 8-Digit Counter w/Lithium Battery CUB2L800Bulletin No. CUB2L8-DDrawing No. LP0348Released 07/14Tel +1 (717) 767-6511Fax +1 (717) 764-0839www.redlion.net

/ 2

Related manuals for red lion CUB2L8