lapara LA-VST-1000-LCD User Manual

lapara LA-VST-1000-LCD User Manual Manual pdf 1 page image

____________________________________________________ _________________________________________________LA-VST-LCD (V.1.1 2011) LA-VST-LCD (V.1.1 2011)CAUTION: NEVER connect a laser printer or scanner to theUPS unit. This may cause the damage of the unit.4 hours1. Package ContentsYou should have received the following items inside of package:- UPS Unit - Quick Guide- USB Cable - CD Software- Power cable (only in LA-VST-1500/2000-LCD)2. Product OverviewFront view:Back View3. Installation and Initial StartupENLine Interactive UPS LA-VST-1000/1500/2000-LCD NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package isdamaged.Placement & Storage ConditionsInstall the UPS in a protected area that is free of excessive dust and has adequate air flow.Please place the UPS away from other units at least 20 cm to avoid interference. Do NOToperate the UPS where the temperature and humidity is outside the specific limits. (Pleasecheck the specs for the limitations.)LCD Display:Display LCDLCD DisplayOn-Off switch On-Off switchLCD DisplayX Input VoltageY Output VoltageZ AC mode indicatorConnect to Utility and ChargingPlug in the AC input cord to the wall outlet. For the best results,suggest charging the battery at least 4 hours before initial use.The unit charges its battery while connecting to the utility.[ Battery mode indicator\ Load level indicator, flashingindicates overload] Battery capacity indicator, flashingindicates low batteryConnect the LoadsPlug in the loads to output receptacles on the rear panel of theUPS. Simply turn on the power switch of UPS unit, then devices connected to the UPS will beprotected by UPS unit.X Output receptaclesY AC InputZ USB portConnect Modem/Phone for Surge ProtectionConnect a single modem/phone line into surge-protected “IN” outlet on the back panel of theUPS unit. Connect from “OUT” outlet to the computer with phone line cable.[ Modem/phone surgeprotection Connect Communication Cable\Circuit breaker To allow for unattended UPS shutdown/start-up and status monitoring, connect one end ofthe communication cable to the USB port and the other to the communication port of your PC.With the monitoring software installed, you can schedule UPS shutdown/start-up andmonitor UPS status through PC.Turn On/Off the UnitTurn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing againthe power switch.

/ 2

Related manuals for lapara LA-VST-1000-LCD