lancer Sensation 30 Installation Manual

Contents

lancer Sensation 30 Installation Manual Manual pdf 2 page image

2• WARNING: Carbon Dioxide (CO2) is a colorless, noncombustible gas with a light pungent odor. High percentages of CO2 maydisplace oxygen in the blood.• WARNING: Prolonged exposure to CO2 can be harmful. Personnel exposed to high concentrations of CO2 gas will experiencetremors which are followed by a loss of consciousness and suffocation.• WARNING: If a CO2 gas leak is suspected, immediately ventilate the contaminated area before attempting to repair the leak.• WARNING: Strict attention must be observed in the prevention of CO2 gas leaks in the entire CO2 and soft drink system.5 Carbon Dioxide (CO2)Provide an adequate potable water supply. Water pipe connections and fixtures directly connected to a potable water supply mustbe sized, installed, and maintained according to federal, state, and local laws. The water supply line must be at least a 3/8 inches(9.525 mm) pipe with a minimum of 25 PSI (0.172 MPA) line pressure, but not exceeding a maximum of 50 PSI (0.345 MPA).Water pressure exceeding 50 PSI (0.345 MPA) must be reduced to 50 PSI (0.345 MPA) with the provided pressure regulator. Usea filter in the water line to avoid equipment damage and beverage off-taste. Check the water filter periodically, as required by localconditions. The water supply must be protected by means of an air gap, a backflow prevention device or another approved methodto comply with NSF standards. A leaking inlet water check valve will allow carbonated water to flow back through the pump when itis shut off and contaminate the water supply. Ensure the backflow prevention device complies with ASSE and localstandards. It is the responsibility of the installer to ensure compliance.! Water NoticeSPECIFICATIONSDIMENSIONSWidth: 30.0 inches (762 mm)Depth: 31.0 inches (787 mm)Height: 37.25 inches (946 mm)WEIGHTShipping: 335 lbs (152 kg)Empty: 275 lbs (125 kg)Ice Capacity: 250 lbs (113.6 kg)Ice Dispensable: 185 lbs (84 kg)CARBON DIOXIDE (CO2) SUPPLYMin Pressure: 70 PSIG (0.483 MPA)Max Pressure: 80 PSIG (0.552 MPA)FITTINGSCarbonator Inlet: 3/8 inch barbPlain Water Inlet: 3/8 inch barbBrand Syrup Inlets: 3/8 inch barbELECTRICAL115 VAC / 60 Hz / 3.0 AmpsPLAIN WATER SUPPLYMin Flowing Pressure: 75 PSIG (0.516 MPA)CARBONATED WATER SUPPLYMin Flowing Pressure: 25 PSI (0.172 MPA)Max Static Pressure: 50 PSI (0.345 MPA)This unit emits a sound pressure level below 70 dBYour Service Agent:Service Agent Telephone Number:Serial Number:Model Numer:Check the dispenser name plate label, located behind the splash plate, for the correct electrical requirements of unit. Do not pluginto a wall electrical outlet unless the current shown on the serial number plate agrees with local current available. Follow all localelectrical codes when making connections. Each dispenser must have a separate electrical circuit. Do not use extension cords withthis unit. Do not ‘gang’ together with other electrical devices on the same outlet. The keyswitch does not disable the line voltage tothe transformer primary. Always disconnect electrical power to the unit to prevent personal injury before attempting any internalmaintenance. The resettable breaker switch should not be used as a substitute for unplugging the dispenser from the power sourceto service the unit. Only qualified personnel should service internal components of electrical control housing. Make sure that allwater lines are tight and units are dry before making any electrical connections!F Electrical WarningThis manual was developed by the Lancer Corporation as a reference for the owner/operator and installer of thisdispenser. Please read this guide before installation and operation of this dispenser. If service is required please call yourLancer Service Agent or Lancer Customer Service. Always have your model and serial number available when you call.READ THIS MANUAL