lancer FS 22 Installation Manual

Also see for FS 30: Operation manual Installation and service manual Instruction sheet

Contents

lancer FS 22 Installation Manual Manual pdf 10 page image

10Cleaning and Sanitizing Syrup Lines - Bag in Box1. Disconnect syrup lines from BIB’s2. Place syrup lines, with BIB connectors, in a bucket of warmwater.3. Activate each valve to fill the lines with warm water and flushout syrup remaining in the lines.4. Prepare Cleaning Solution described above.5. Place syrup lines, with BIB connectors, into cleaningsolution.6. Activate each valve until lines are filled with cleaningsolution then let stand for ten (10) minutes.7. Flush out cleaning solution from the syrup lines using clean,warm water.8. Prepare Sanitizing Solution described on previous page.9. Place syrup lines into sanitizing solution and activate eachvalve to fill lines with sanitizer. Let sit for ten (10) minutes.10. Reconnect syrup lines to BIB’s and draw drinks to flushsolution from the dispenser.11. Taste the drink to verify that there is no off-taste. If off-tasteis found, flush syrup system again.Ice Chute Cleaning1. Turn off power to the dispenser.2. Remove Merchandiser.3. Remove Ice Chute Lever, then remove Splash PlateAssembly by lifting it up and out from the dispenser face.4. Remove the Ice Chute Assembly base by removing the four(4) screws that attach it to the unit.5. Prepare the Cleaning Solution.6. Soak the Ice Chute Assembly in the solution.7. Rinse and dry the Ice Chute Assembly thoroughly.8. Reinstall the Ice Chute Assembly.9. Reinstall Merchandiser and Splash Plate.10. Reconnect power to the dispenser.It is recommended to perform this procedure monthly,or more often if desired. Use the cleaning solutiondescribed above. An alternate solution of one partwater to one part vinegar may be used to removewater spots and calcium deposits.NOTEAlways remove the ice chute lever before removingthe splash plate.NOTEFollowing sanitization, rinse with end-use productuntil there is no aftertaste. Do not use a fresh waterrinse. This is a NSF requirement. Residual sanitizingsolution left in the system creates a health hazard.! CAUTIONWiring and Plumbing Diagrams - FS22WIRING DIAGRAM FS22AGITATORICE DOORSOLENOIDREMOTE PUMPKEYSWITCHLED COMMUNICATION LIGHTSLED NOTE:FLASH WHEN COMMUNICATINGPROBEICESWITCHNOZZLENOZZLEV2 V1BLACKBLACKWHITEBLACKWHITEBLACKPOWERSUPPLYCONTROLLERBOARDDISPLAYCARB/AGI FOTCOMM ICE OPTIC ICE DOOR ICESWITCH KEY SOLD OUTJV1JV2JV3JV4CARB PROBEPOWERCARBONATOR BALLAST ICEAGITATORCARB/AGI CONTROLLERPOWERLIGHTINGRESETTABLESWITCHPOWERCORDBLKWHTGRNTRANSFORMERBLKGROUND TOICE DOORSOLENOIDSCREW