kingsley-bate CO-30 Assembly Instructions Manual

kingsley-bate CO-30 Assembly Instructions Manual Manual pdf 1 page image

KINGSLEY–BATEFine Garden FurnitureASSEMBLY INSTRUCTIONS FOR THE CO-30/55/80BACK SEAT INSERTS SEAT*NOTEA TENONB MORTISE HOLEEND FRAME END FRAMESTEP-IUnpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.NOTE: During assembly of the furniture please match all joints with the correspondingletters or numbers stamped on the furniture.STEP-IICarefully lay down the END FRAME with the stamped numbers or letterson it and fit the SEAT & BACK tenons into the END FRAME mortiseholes as shown in the assembly photograph. If necessary, gently rock theSEAT & BACK while pushing the tenons into place until the joints fitsnugly together (use a rubber mallet to drive the joints together ifnecessary).STEP-IIIFit the remaining END FRAME mortise holes over and onto all exposedtenons. Using a rubber mallet or regular hammer with a wood blockbetween the hammer and the wood, drive the tenons and mortise holesuntil all the joints fit snugly together.

/ 2

Related manuals for kingsley-bate CO-30