Menu
i4Home Smart Box Eco Quick Installation Manual
  |
Quick Installation GuideGet StartedEasy as One, Two, ThreeStep 1: Getting StartInstall the Smart Box:Ethernet Version:Connect the i4Home Smart Box to your routerand into your wall outlet accordingto the picture provided.Then wait for the booting process to finish(it will automatically boot, and should take less than 1 minute)You will know the booting process is finishedwhen the green LED light flashes slowlyWi-Fi Version:Please refer to the Wi-Fi Adaptor Settings guideStep 2. to add sensors or any device to i4Home app of your Smart boxPress “Device” button from i4Home App and then press “Install” buttonYou will hear Buzzer beeps from the Smart Box and all LEDs blink simultaneously(This means the system is ready for adding device within 30 second)Then select your “Device Type” according to the device you want to enroll it- Remote Control: i4H-RC-31- Apply Step 2 and set the device type to “Remote”2- Press the Disarm button of the RC-3 for two seconds.You will hear 3 short beeps and your device added successfullyNow you can press any button to check the R/C in the i4Home App’s StatusRemarks:- If you will hear one long beep after 30 seconds that means the adding failed, so you have to repeat enrolling action again- Avoid activating any other sensors during the 30 seconds Device Enroll period- Door/Window Sensor: i4H-MX-3DOpen the case and insert a 3V CR-2032 Lithium battery1- Apply Step 2 and set the device type to “Door”2- Within 30 seconds place the small magnet piece closelyto the mark of the transmitter, or place it away from the transmitter if they are close originally.You will hear 3 short beeps and your device is added successfullyNow you can move the magnet back and forth to check it in the i4Home App’s StatusRemarks:- If you will hear one long beep after 30 seconds that means the adding failed, so you have to repeat enrolling action again- Avoid activating any other sensors during the 30 seconds Device Enroll period- Motion Sensor: i4H-PIR-3SPLoosen the screw at the bottom of the motion sensor, and then remove the front cover.Insert two AA alkaline batteries and keep it open to be able to add it to the Smart Box1- Apply Step 2 and set the device type to “Motion”2- Within 30 seconds, press the TEST button on the motion sensor boardYou will hear 3 short beeps and your device is added successfullyNow you can press the test button again to check it in the i4Home App’s StatusThen you can close the sensor front coverPage 2Download i4Home App:- Download “i4Home” application from your smartphone’s Appstore (Google Play or Apple Store)Your registration ID Serial number is located on the back of theSmart Box and make a note of it as it will be required whenregistering your device online.- Launch i4Home App, and register your Smart Box using theregistration form (Register Button) and then you will receive aconfirmation email to activate your accountEnsure that you have enabled push notifications option on yoursmartphone- Login in to i4Home app using your username and passwordStep 2: Adding your Sensors: (Enroll Devices)Before adding any new device, you have to insertBatteries to device or connect it to the power supply.It is recommended to bring device closer to Smart BoxPage 1 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved