Menu
aci AIM2 Installation & Operation Instructions
        |
Automation Components, Inc.2305 Pleasant View Road | Middleton, WI 53562Phone: 1-888-967-5224 | Website: workaci.comPage 1Version: 9.0I0000585FIGURE 1: DIMENSIONSINTERFACE SERIESInstallation & Operation InstructionsAIM2Phone: 1-888-967-5224Website: workaci.comGENERAL INFORMATIONThe AIM2 optically isolates an analog (voltageor current) input signal from itscorresponding output signal. It will acceptany input signal between 0 and 20 VDC, or 0and 20 mA, and output any signal withinthose ranges. The AIM2 has preset oradjustable inputs and preset or adjustableoutputs that can be either voltage or current.The current signals on the input or output canbe either sink or source. The AIM2 requiresone external 24 VAC isolation transformerwith floating secondary for power. It has anonboard 24 VAC isolation transformer tosupply power to the isolated output. TheAIM2 is field calibratable, however, factorycalibration is available upon request for anadditional charge. This will speed upinstallation time for the end user.MOUNTING INSTRUCTIONSGround yourself to discharge static electricitybefore touching any electronic equipment, assome components are static sensitive. Theinterface device can be mounted in any position. If circuit board slides out of snap track, a non-conductive“stop” may be required. Use only fingers to remove board from snap track. Slide out of snap track or pushup against side of snap track and lift that side of the circuit board to remove. Do not flex board. Do notuse tools.WIRING INSTRUCTIONSPRECAUTIONS• Remove power before wiring. Never connect or disconnect wiring with power applied.• When using a shielded cable, ground the shield only at the controller end. Grounding bothends can cause a ground loop.• This device needs to have its own Isolated Transformer. This transformer cannot beconnected/or shared with any other device. It is recommended you use an isolated UL-listed class2 transformer.• All wiring must comply with all local and National Electric Codes.I4.60” (116.84mm)3.23”(81.90mm)3.25”(8255mm)4.69” (119.13mm)0.70”(17.78mm) |
Related manuals for aci 101794
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved