abi PIXI TILE INSERT Installation Manual

abi PIXI TILE INSERT Installation Manual Manual pdf 1 page image

SPECIFICATIONSRECOMMENDED USECONSTRUCTIONDisclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right tovary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI andthe manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2021.Note: Dimensions are nominal measurements onlyINSTALLATION GUIDENote: This product must be installed by a licensed plumber.This is a general installation guide - there are many factors thatare involved that can alter the installation method. This productinstall must comply with AS/NZS 3500.IMP ORTANT: Spindle set backs are critical, refer to following pages for more detailsPIXI TILE INSERTASSEMBLY HANDLE KITDomesticSolid BrassFront ViewTop View A-ABack ViewNote: Dimensions are nominal measurements onlyAA10 10655064413153Ø57 (max tile)G1/28 6M5x0.9x4M5x0.9x420.5655365605445151 Screw backplate on to spindle & tighten firmly. 2 Mount spindle attachment to spindle.* IMP ORTANT:Ensure spindles are in the of f position, turn clockwiseto turn of f cold and anti-clockwise for hot3 Place cut tile on face of spindle attachmentand push both back and for th to align tileface with the face of the handle. Tile faceshould finish 43mm from face of base plate.4 1. Remove tile from spindle attachment.2. Fix spindle attachment into postion by inser tingand tightening M5 grub screw using allen keyprovided.5 Put a small amount of silicone on the front perimeterof the tile and push into handle and screw both on tobase plate.How to orientate H/C sybmbol.At this point note where the symbol is located whenthe handle is in the of f position. Mark with a pencilthe position it needs to be. Return to step 2 and adjustthe base plates orientation by the referenced amount.6 1. Screw handle on to spindle attachment, whileholding then tile in disired position.2. Fix handle into postion by inser ting andtightening the grub screw using allen keyprovided.1.2.IN THE BOX2x Backplate 2x Spindle Att.2x Handles 1x 5mm Allenkey 4x M5 Grub Screw1x Diamond Hole Saw43mm1.2.SILICONEDO NOT use creamcleaners or bleach.These substances areabrasiveRegularly clean withmild liquid detergentor soap and waterDO NOT use cleaningpads with abrasivesur faces as this mayscratch the material

/ 3

Related manuals for abi PIXI TILE INSERT