Menu
abc GE-8 Starguide III Quick Start Manual
         | |
sg3_QS_GE8 03/22/01 Page 1 of 1ABC GE-8 STARGUIDE III SATELLITE RECEIVERQUICK STARTPLEASE REVIEW THIS QUICK START GUIDE IN ITS ENTIRETYBEFORE INSTALLING YOUR RECEIVER.• It is critical to make all satellite RF and audio connections priorto applying AC power to the Starguide receiver.• The Starguide III receiver must be powered down before youinstall or remove any option cards located in the expansionports. None of the cards in the receiver are “hot-swappable”.• ABC strongly recommends the use of a Phase Lock Loop (PLL)LNB for your new Starguide receiver. The Local Oscillator (LO)stability of your LNB should not exceed 100kHz.• If this receiver is designated to supply DC power to the LNB atyour dish, be sure to turn on the LNB VOLTAGE switch on theback of the receiver.• ABC urges stations to use an Uninterruptible Power Supply(UPS) for the Starguide receiver for equipment protection frompower spikes or brownouts. Also consider lightning protectionif you are located in an area susceptible to frequent lightningstorms. A surge suppressor is not sufficient.• The ABC Radio Networks New York Technical Services office isstaffed Monday-Friday from 9:00am until 5:00pm ET forreceiver authorization and technical assistance.(212) 456-5000 – option #4(212) 456-5708 – faxE-MAIL: techservices@abc.com |
Related manuals for abc GE-8 Starguide III
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved