Zodiac Sweepy M3 User Manual

Contents

Zodiac Sweepy M3 User Manual Manual pdf 4 page image

How to install your Sweepy M3™ ?1. Unpacking• The following items should be in the packaging :- your Sweepy M3™ robot- its carrying trolley including the control box• Make sure your appliance has not been damaged in transit (impact, broken parts etc.). If you noticethe slightest fault, however minor, do not hesitate to contact your retailer before using yourSweepy M3™.• Assembling the carrying trolleyBefore removing the appliance from the box :- Loosen the round black knobs on the transport trolley as far as they will go (they should pull out byapproximately 1 cm) ;- Fold out the carrying trolley (Fig. 1) ;- Retighten the black knobs on the trolley (Fig. 2) ;Take the robot out of the box, then the trolley ;- Put the hooks used to rewind and store the cable towards the rear (Fig. 3).2. Electrical ConnectionFor your own safety and to ensure that your Sweepy M3™ functions properly, proceed as follows:• Put the control box at least 3.5 metres away from the edge of the pool avoiding direct exposure tothe sun.• Fix to the ground using the fixing dowels supplied, and lock the trolley foot into them to immobilisethe trolley (Fig. 4).• Connect the robot cable to the control box and screw the connector tight.• Lift the lid of the control box (Fig. 5).• Make absolutely sure that the «I/O» [On/Off] switch is set to «O» (Fig. 6) ; the robot may beseriously damaged if it is switched on whilst it is out of the water.• Only connect the control box to an earthed electrical socket fitted with a maximum 30 mA residualcurrent protection device (if you are not sure, contact your installer’s electrician ).161