Zip Hydroboil HS010 Installation And Operating Instructions Manual

Also see for Hydroboil HS010: Installation and operating instructions

Contents

Zip Hydroboil HS010 Installation And Operating Instructions Manual Manual pdf 8 page image

Page 8 of 12 Zip Hydroboil - Installation & Operating Instructions - 81447 - February 2004Wiring DiagramsOperating proceedures continuedReading the Display ScreenPower OnWhen the text 'Power On' is illuminated this indicates that the power isconnected and turned on and that the heater is operating normally.Boiling WaterWhen the text 'Boiling Water' is illuminated this indicates that the contents ofthe boiling chamber has been brought to boiling point and is being maintained(normally within 1°C of boiling point). During the initial heat-up the contents ofthe boiling chamber may be below boiling point for a period, and during thatperiod the text 'Boiling Water' may not be illuminated.Filter ActiveIf your Zip Hydroboil is specified with a filter the ‘ Filter Active’ text will normallybe illuminated. This indicated that the filter is within its specified lifespan.Change FilterIf your Zip Hydroboil is specified with a filter the ‘Change Filter’ light willilluminate when the filter is due to replacement. The local toll free number(directly above) will also illuminate showing the Zip service number.Cleaning CaseDo not use strong, corrosive, spray or abrasive cleaners. Clean the case with asoft cloth or brush and mild soap and water.Boiling WaterDisplay Screenreset t.o.l.thermostatt ºelementassemblyelementt.o.l.fascia lightsN LSingle Element with Thermal OverloadWiring Diagram for 10,15 and 25 Litre. 40 Litre Wiring Diagram