Zip HydroTap series Installation & Operating Instruction

Contents

Zip HydroTap series Installation & Operating Instruction Manual pdf 8 page image

Page 8 of 16 Zip Hydro Tap Installation and Operating Instructions - 81759 - February 2013 v2.01Font installation procedureA font kit installation is available for this product and is sold separately asan accessory. For details of the available font kits, please contact your Zipcustomer service provider. The font instalation instructions and mountingtemplate are supplied with the font kit.Operating the TapBlue Chilled Water LightOn all the time:This indicates that the unit is ON.Flashing slowly :This indicates that the chilled water is not at the right temperature. Wait up to20 minutes. When the chilled water is at the right temperature, the light willstop flashing. Note: The Zip HydroTap is designed to dispense chilled water inthe temperature range 5°C to 10°C.During heavy usage, the temperature can rise out of this range.Filter Change Light Off: This indicates the filter is operating within its normalspecified lifespan.Filter Change Light Flashing slowly : The light will flash slowly when thefilter is due for replacement and the LCD will show “Filter Change”. Refer to“Replacing the filter” section of this document.Chilled Water LeverDepressing the “Blue” lever allows dispensing of Chilled water.Pulling up the Blue lever allows the tap to operate in a “no-touch” mode.Water will flow from 5 to 15 seconds (factory preset). To reset, return thehandle to the “Off” position and repeat the step. The lever has to be manuallyreturned to the “Off” position. Should an alternate dispensing time be neededrefer to page 15, Water Dispensing.Note: On the Chilled only modelsthe Red LED is blank.ChilledFilter ChangeCHILLEDCHILLED