Menu
Zgonc Gardenline YGL N.G. 51/2 Translation From The Original Instruction Manual
                                    | |
31GBand let it run until the equipment stops.3 Leave the engine to cool (approx. 5 minutes).4 Remove the spark plug (see section 10 Change andclean the spark plug).5 Add one teaspoon of 2-stroke engine oil into the com-bustion chamber. Slowly pull the starter cord severaltimes to apply a layer of oil to all internal components.Fit the spark plug again.Note: Store the equipment in a dry place and far awayfrom possible ignition sources such as an oven, a gas-fired hot water boiler, a gas-fi red dryer, etc.Putting the equipment back into operation1 Remove the spark plug (see section 10 Change andclean the spark plug).2 Quickly tug on the starter cord to remove excess oilfrom the combustion chamber.3 Clean the spark plug and check that the electrode gapis correct, or insert a new spark plug with the correctelectrode gap.4 Prepare the equipment for operation.5 Fill the tank with the relevant mixture of fuel and oil.See the section „Fuel and oil“.TransportTo transport the machine, empty the petrol tank asdescribed in section 8 draining fuel. Clean coarse dirt offthe equipment with a brush or hand brush.12. Disposal and recyclingThe equipment is supplied in packaging to prevent itfrom being damaged in transit. The raw materials inthis packaging can be reused or recycled. The equip-ment and its accessories are made of various types ofmaterial, such as metal and plastic. Defective compo-nents must be disposed of as special waste. Ask yourdealer or your local council.Storing the unitAfter cutting, clean the unit thoroughly. Store the unit in adry room allow the motor to cool down beforehand.Important hint in case of sending the equipment to aservice station:Due to security reasons please see to it that theequipment is sent back free of oil and gas!Ordering replacement partsPlease quote the following data when orderingreplacementparts:• Type of machine• Article number of the machineReplacement parts / accesories:For the cutting equipment listed here, you can always usethe safety guards provided with the unit.Grass trimmer/brush cutter:Spool with Ø 450 7910700707Blade with 3 teeth Ø 255 x 1.4 7910700702Transport guard for blade 3 teeth 3904801065Blade with 4 teeth Ø 255 x 1.5 7910700705Transport guard for blade 4 teeth 3904801066Blade with 8 teeth Ø 255 x 1.5 7910700711Transport guard for blade 8 teeth 3904801066Safety shield for grass trimmer 390480303411. StorageCleaning• Keep handles free of oil, so you always have a securehold.• Clean the equipment as required with a damp clothand, if necessary, mild washing up liquid.m Important!• Always pull out the spark boot plug each time beforecarrying out any cleaning.• Never immerse the equipment in water or other liquidsin order to clean it.• Store the chainsaw in a safe and dry place out of thereach of children.StorageImportant: Never put the equipment into storage forlonger than 30 days without carrying out the followingsteps.Storing the equipmentIf you intend to store the equipment for longer than 30days, the equipment must be prepared accordingly.Otherwise the fuel still remaining in the carburetor willevaporate and leave a rubbery sediment. This can cau-se problems when starting up the equipment and mayrequire expensive repairs.1 Slowly remove the fuel tank cap to release any pres-sure that may have formed in the tank. Carefully emptythe tank.2 To remove the fuel from the carburetor, start the engine |
Related manuals for Zgonc Gardenline YGL N.G. 51/2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved