Zenith SYSTEM 3 Series Operating Manual And Warranty

Also see for SYSTEM 3 Series: Operating guide & warranty Operating guide & warranty Operating guide & warranty Operating guide

Zenith SYSTEM 3 Series Operating Manual And Warranty Manual pdf 28 page image

SETUP MENUCLOCK SETPurposeSets the clock in the TV to the correct time.After the time is set, the current time will appear on theChannel/Time display whenever the TV is turned on, thechannel is changed, or ENTER (ENT) is pressed.Power Failure Note: The time will have to be reset if powerto the TV is interrupted.SETUP MENUAUTO CH. SEARCHCH. ADD/DELCH. LABELSTUNING BANDAUTO FINE TUNECLOCK SETCAPTIONSCH. BACKGROUND10:30To Use CLOCK SET from Remote Control1. CLOCK SET should be selected if you followed the"Basic Menu Operation" given in the "On-ScreenMenus" section.2. Use the numbered buttons on the remote control toenter the current time. Press ENTER (ENT) to startthe clock.For example, to set the clock to 12:30, press 1, then 2, then3, then 0; and then press ENTER (ENT). If you enter an in-valid time, such as 14:35 or 2:80, the time will disappear andyou can enter another time.To Use CLOCK SET from Control Panel1. CLOCK SET should be selected if you followed the"Basic Menu Operation" given in the "On-ScreenMenus" section.2. Use ADJUST (ADJ) Left/Right to set the time, andthen press ENTER (ENT)to start the clock.Selecting Clock SetCAPTIONSPurposeDisplays closed captions (CC) or informational text whenavailable on the selected channel.To Access CAPTIONS Indirectly (All Models)I. CAPTIONS should be selected if you followed the"Basic Menu Operation" given in the "On-ScreenMenus" section.2. One of five different selections is shown: OFF,CAPTION 1, CAPTION 2, TEXT 1 and TEXT 2.3. Press ADJUST (ADJ) Left/Right to select desiredmode of operation.4. The display disappears from the screen automat-ically in about 10 seconds, or you may press ENTER(ENT) to remove the display immediately.To Access CAPTIONS Directly (Select Models)1. Press CAPTIONS or CC/QUIT on the remote con-trol to select CAPTIONS. One of five different selec-tions is shown: OFF, CAPTION 1, CAPTION 2,TEXT 1 and TEXT 2.2. Press ADJUST (ADJ) Left/Right to select desiredmode of operation.3. The display disappears from the screen automat-ically in about 10 seconds, or you may press ENTER(ENT) to remove the display immediately.(continued on next page)SETUP MENUAUTO CH. SEARCHCH. ADD/DELCH. LABELSTUNING BANDAUTO FINE TUNECLOCK SETCAPTIONSCH. BACKGROUNDCAPTION 1Selecting Captionsz577.s 8 -- 4