Zenith SYSTEM 3 SY2738RK Operating Manual & Warranty

Contents

Zenith SYSTEM 3 SY2738RK Operating Manual & Warranty Manual pdf 30 page image

SOURCE MENU_ ourceMenu[Main SourcePIP Source] [Antenna/CableMENU OPERATIONPress MENU repeatedly until theSource Menu is shown.Press the Up or Down arrowrepeatedly until the desired option isselected.(ADJUSD(SELECl3Use the Left or Right arrow to adjustthe selected option.Press QUIT or wait a few secondsfor the TV to return to normaloperation.Menu Option Purpose of Menu OptionMain Source Selects the television's input signal source for basic television viewing. In other words, will your primarytelevision viewing be from the antenna or cable box that is connected to the Antenna/Cable jack on the backof the TV. Or, will you mostly watch TV via a VCR (or other audio/video device) connected to the A/Vjacks on the back of the TV. Select either Antenna/Cable or Video.PIP Source Selects the television's input signal source that is providing the video for the PIP window. Select eitherAntenna/Cable or Video.NOTE:Q The sources may also be changed directly by pressing the SOURCE key on the remote control. When no PIP window is on, theSOURCE key selects the source for the main picture. If the PIP window is on, SOURCE selects the source for the PIP window.PIP WindowUse the arrow keys toplace the window any-where on the TV screen.Main Picture AreaIn order to show two _ channels on the TV at the same time, one signal source(antenna, cable box, etc..) must be connected to the Antenna/Cable jack and a differ-ent signal source (VCR, Laser Disk, etc..) must be connected to the A/V jacks.3050-0 10 -- 1