Enter/Exit Programming ModeScan this barcode to enter the set-up and exitafter set-up is finished. The LED would remainred when in programming mode.Display firmware versionShow the current firmware version on the hostscreen.Return to PC/AT defaultThis barcode allows setting as keyboardwedge interface for IBM PC AT/PS/2 andcompatibles.Return to RS-232 defaultThe RS-232C interface scanner is often usedwhen connecting to the serial port of a PC orterminal.Return to USB defaultReading of “Return to USB default” sets thedevice into USB interface support.Reset (Return to Factory Default)Reading of “Reset” barcode label turns allparameters back to default values, and thescanner remains in the last interface set when it isreset.* Since the scanner has a large scan volume and multiple scan lines, it is suggested to fold thispage according to the dotted line so you can easily present the desired barcode to the scanner.* The scanner must be properly powered before programming. It would acknowledge a good andvalid reading with a short beep.* For more set-up selections, please refer to Programming Guide in the CD-ROM in thepackage.Folding LineFolding LineVer. 1.1P/N: 593-66182E-201Important NoticeNo warranty of any kind is made in regard to this material, including, but not limited to, implied warranties of merchantability or fitness for aparticular purpose. We are not liable for any errors contained herein or incidental or consequential damages in connection with furnishing,performance or use of this material.Copyright © 2011. All rights reserved.Laser SafetyThe laser scanner complies with safety standard IEC 60825-1 for a Class I laser produce. It also complies with CDRH as applicable to a ClassIIa laser product. Avoid long term staring into direct laser light.CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardousradiation exposure.Folding Line