Zaxcom ERX2TCD User Manual

Contents

Zaxcom ERX2TCD User Manual Manual pdf 14 page image

Zaxcom ERX3TCD Interfacing with a NomadPage 14ERX Quick Start Guide - Interfacing with NomadInterfacing the ERX with a Nomad1. In the main menu of Nomad select ZaxNet Setup2. Scroll down and select Input Configure. Make sure that the input configure is set to 8 or higher. Press theback button and return to the ZaxNet Setup Menu.3. Power cycle your Nomad4. Return to the ZaxNet setup menu scroll up and select IFB Mode. Make sure that it is set to TX or TX+RX5. Scroll down and select the transmit frequency.6. Scroll down to choose a group code.7. Power on the ERX while holding the menu button to access the extended menu.8. Advance to the time code frame-rate menu and set the frame rate to the same frame rate that Nomad is setto or turn on the auto-frame rate option.9. Press the menu key to enter the IFB frequency select menu. Set the receive frequency the same as thetransmit frequency that is set in Nomad or turn auto frequency select. If the ERX is receiving a good signal,there will be two vertical signal strength bars on the right side of the screen.10. Advance to the time code output enable menu. If using the ERX as an IFB for a personal monitor leave thetime code output set to OFF. If the ERX is being used to output time code select “OUT LEFT TIP” or “OUTRIGHT” or “BOTH”.11. If the camera has trouble seeing time code, proceeded to the TC output level menu and adjust the time codevoltage level until the camera recognizes the time code.12. In the Nomad BUS MENU advance to the TAPE / IFB out and route the audio to the ERX. Anycombination of card tracks, outputs or returns can be selected.