Zanussi ZWT71201WA User Manual

Also see for ZWT 71201 WA: User manual User manual

Contents

• a) DoorThe dimensions of the door should be:- width 595-598 mm- thickness 16-22 mmThe height (C-Fig. C) depends on the heightof the adjacent furniture's base.• b) HingesTo mount the hinges it is necessary to drilltwo holes (dia. 35 mm, depth 12.5-14 mmdepending on the depth of door furniture) onthe inner side of the door. The distance be-tween the holes hobs fixing centres must be416 mm.The distance (B) from upper edge of the doorto the centre of the hole depends on the ad-jacent furniture's dimensions.The required dimensions are given in the pic-ture C.The hinges will be fixed to the door by meansof screws for wood (2-Fig. B) supplied withthe appliance.• c) Mounting the doorFix the hinges (1) to the machine by means ofthe M 5x15 screws (3-Fig. B). The hingescan be adjusted to compensate for possibleuneven thickness of the door.To align the door perfectly it is necessary toloosen the screw (3-Fig. B), adjust the doorand tighten the screw again.D468Caution! Do not remove the screw 8!d) Counter-magnet (6)The appliance is prearranged for a magneticclosure of the door.To enable a correct operation of this device, itis necessary to screw the counter-magnet (6)(steel disk + rubber ring) into the inner sideof the door. Its position must correspond tothe magnet (4) on the appliance (see pictureD).E12375648Caution! Do not remove the screw 8!If the door has to be opened from left to right,invert the position of the plates (7), the mag-net (4) and the plate (5) (Fig. B and E).Mount the counter-magnet (6) and the hinges(1) as previously described.Recommendations regarding the con-struction and fitting of a base when theinstallation requires an integrated appli-ance to be raised.29www.zanussi.com

/ 32

Related manuals for Zanussi ZWT 71201 WA