Problem Possible solutionThe appliance fills with waterand drain immediately.• Make sure that the drain hose is in the correct position. The end ofthe hose may be too low. Refer to 'Installation instruction'.The cycle is shorter than thetime displayed.• The appliance calculates a new time according to the laundry load.See the ‘Consumption Values’ chapter.The cycle is longer than thetime displayed.• An unbalanced laundry load increases the duration time. This is a nor-mal behaviour of the appliance.The washing results are notsatisfactory.• Increase the detergent quantity or use a different detergent.• Use special products to remove the stubborn stains before you washthe laundry.• Make sure that you set the correct temperature.• Decrease the laundry load.You cannot set an option. • Make sure that you press only the wanted touch button(s).After the check, activate the appliance. Theprogramme continues from the point ofinterruption.If the problem occurs again, contact theAuthorised Service Centre.If the display shows other alarm codes.Deactivate and activate the appliance. If theproblem continues, contact the AuthorisedService Centre.ServiceWe recommend the use of original spare parts.When contacting the Authorised ServiceCentre, make sure that these data are available.You can find the information on the rating plate:model, PNC and Serial Number. (Mod., Prod.No., Ser. No.)Technical DataDimension Width/ Height/ Depth/ Totaldepth600 mm/ 850 mm/ 600 mm/ 660 mmElectrical connection VoltageOverall powerFuseFrequency230 V2200 W10 A50 HzLevel of protection against ingress of solid particles andmoisture ensured by the protective cover, except where thelow voltage equipment has no protection against moistureIPX4Water supply pressure MinimumMaximum0,5 bar (0,05 MPa)8 bar (0,8 MPa)Water supply 1) Cold waterMaximum Load Cotton 9 kgEnergy Efficiency Class A+++ -20%Spin Speed Maximum 1400 rpm1) Connect the water inlet hose to a water tap with a 3/4'' thread.www.zanussi.com 17