Zanussi ZWD96SB4PW User Manual

2. Loosen or tighten the feet to adjust the level. Allfeet must rest firmly on the floor.WARNING! Do not put cardboard,wood or equivalent materials belowthe appliance feet to adjust the level.The inlet hoseCAUTION! Make sure there is nodamage to hoses and there are noleaks from the couplings. Do not usean extension hose if the inlet hose istoo short. Contact the service centrefor a replacement inlet hose.1. Connect the water inlet hose to the back of theappliance.20º20º45º45º2. Position it toward left or right depending on thepositon of the water tap. Make sure that the inlethose is not in vertical position.3. If necessary, loosen the ring nut to set it in thecorrect position.4. Connect the water inlet hose to the cold watertap with 3/4'' thread.WARNING! The inlet water shall notexceed 25 °C.Water drainageThe drain hose should stay at a height of no lessthan 60 cm and not more than 100 cm.You can extend the drain hose tomaximum 400 cm. Contact theauthorised service centre for the otherdrain hose and the extension.It is possible to connect the drain hose in differentways:1. Make a U shape with the drain hose and put itaround the plastic hose guide.2. On the edge of a sink - Fasten the guide to thewater tap or to the wall.Make sure that the plastic guidecannot move when the appliancedrains and the drain hose end is notimmersed in the water. There may be areturn of dirty water into the appliance.3. If the end of the drain hose looks like this (seethe picture), you can push it directly into the standpipe.4. To a stand pipe with vent hole - Insert the drainhose directly into a drain pipe. Refer to theillustration.9