Zanussi ZRB38212WA User Manual

Also see for ZRB38212WA: User manual User manual User manual

Contents

WHAT TO DO IF...Problem Possible cause SolutionThe appliance is noisy. The appliance is not suppor-ted properly.Check if the appliance standsstable.The lamp does not work. The lamp is in stand-by mode. Close and open the door.The lamp does not work. The lamp is defective. Contact the nearest AuthorisedService Centre.The compressor operatescontinually.Temperature is set incorrect-ly.Refer to "Operation"/"Controlpanel" chapter.Many food products were putin at the same time.Wait a few hours and then checkthe temperature again.The room temperature is toohigh.Refer to climate class chart onthe rating plate.Food products placed in theappliance were too warm.Allow food products to cool toroom temperature before storing.The QuickFreeze function isswitched on.Refer to "QuickFreeze function".The compressor does notstart immediately after press-ing the QuickFreeze or afterchanging the temperature.This is normal, no error hasoccurred.The compressor starts aftersome time.Water flows inside the refrig-erator.The water outlet is clogged. Clean the water outlet.Food products prevent waterfrom flowing into the watercollector.Make sure that food products donot touch the rear plate.Water flows on the floor. The melting water outlet isnot connected to the evapo-rative tray above the com-pressor.Attach the melting water outlet tothe evaporative tray.Temperature cannot be set. The QuickFreeze or Quick-Chill function is switched on.Switch off QuickFreeze orQuickChill manually, or wait untilthe function resets automaticallyto set the temperature. Refer to"QuickFreeze or QuickChill func-tion".The temperature in the appli-ance is too low/too high.The temperature regulator isnot set correctly.Set a higher/lower temperature.The food products tempera-ture is too high.Let the food products tempera-ture decrease to room tempera-ture before storage.Many food products werestored at the same time.Store less food products at thesame time.7