Labels supplied with the accessoriesbagStick the adhesive labels as indicated below:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03 ITMADE IN ITALYTYPEIP200049A B CA. Stick it on Guarantee Card and send thispart (if applicable).B. Stick it on Guarantee Card and keep thispart (if applicable).C. Stick it on instruction booklet.InstallationWARNING!Refer to Safety chapters.Before the installationBefore you install the hob, write down theinformation bellow from the rating plate. Therating plate is on the bottom of the hob.Model .......................................PNC .........................................Serial number ...........................Built-in hobsOnly use the built-in hobs after you assemblethe hob into correct built-in units and worksurfaces that align to the standards.Connection cable• The hob is supplied with a connection cable.• To replace the damaged mains cable usethe following (or higher) mains cable type:H05V2V2-F T min 90°C. Speak to your localService Centre.Installation of more than one hob40-50 mm55 mm30 mmmin. 650 mm 490 mmmin. 100 mm270 mmIf several 30 cm hobs are to be installed side byside into the same cut out, an assembly kitincluding a support side bracket andsupplementary seals is available at ourAuthorised Service Centres. The relevantinstallation instructions are supplied within thekit package.www.zanussi.com 9