Menu
Zanussi ZEFIST1001SS User Manual
                        |
7Electric Insert Fire Installation• The Electric heater is supplied with approximately 1.7 meters of flexiblemains cable. The appliance and surround should be located close to asuitable mains socket and MUST be easily accessible to allow properconnection.• This appliance MUST NOT be directly installed on a carpet or similarmaterial. We recommend that it is fitted onto a hearth or similar non-combustible material.• This heater MUST be earthed. If in any doubt consult the manufacturer, itsservice center or a qualified person.• The heater shall be installed into a location that has an opening withminimum dimensions below:• Width: minimum 39 cm (15 1/2”)• Height: minimum 55.5 cm (21 3/4”)• Depth: minimum 11 cm (4 1/4”)• Ensure the appliance is disconnected from supply socket.• Mark the center of the opening space of fireplace, measure 215.5mm to theleft and same to the right. Then measure from the floor 560mm up the wall.This will be the location for the screw.• Once you have fitted the two screws in place (leave a 2mm gap), lift the fireup to the hearth and fit the fire onto the two fixed screws. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved