What to do if...Problem Possible cause RemedyYou cannot activate the appli-ance.The appliance is not connectedto an electrical supply or it isconnected incorrectly.Check if the appliance is correct-ly connected to the electricalsupply.You cannot activate the appli-ance.The fuse is blown. Make sure that the fuse is thecause of the malfunction. If thefuse is blown again and again,contact a qualified electrician.You cannot activate or operatethe hob.You touched 2 or more sensorfields at the same time.Touch only one sensor field.You cannot activate or operatethe hob.STOP+GO function operates. Refer to "Hob - Daily use" chap-ter.You cannot activate or operatethe hob.There is water or fat stains on thecontrol panel.Clean the control panel.An acoustic signal sounds andthe hob deactivates.An acoustic signal sounds whenthe hob is deactivated.You put something on one ormore sensor fields.Remove the object from the sen-sor fields.Residual heat indicator does notcome on.The zone is not hot because itoperated only for a short time.If the zone operated sufficientlylong to be hot, speak to an Au-thorised Service Centre.Automatic Heat Up function doesnot operate.The zone is hot. Let the zone become sufficientlycool.Automatic Heat Up function doesnot operate.The highest heat setting is set. The highest heat setting has thesame power as the function.The heat setting changes be-tween two levels.Power management function op-erates.Refer to "Hob - Daily use" chap-ter.The sensor fields become hot. The cookware is too large or youput it too near to the controls.Put large cookware on the rearzones if possible.comes on the hob display. Automatic Switch Off operates. Deactivate the hob and activate itagain.comes on the hob display. The Child Safety Device or theLock function operates.Refer to "Hob - Daily use" chap-ter.comes on the hob display. There is no cookware on thezone.Put cookware on the zone.comes on the hob display. The cookware is incorrect. Use the correct cookware.Refer to "Hob - Hints and tips"chapter.22 www.zanussi.com