ZDC Air Access ZA-5000 Series User Manual

ZDC Air Access ZA-5000 Series User Manual Manual pdf 16 page image

ZDC ZA-5000 User's Manual V2.2.5Chapter 2 Hardware Installation Page 6Chapter 2 Hardware InstallationSystem Requirement Two PCs with RJ-45 connector NIC supporting the transfer rate of 10/100Mbps data. The IP address of NIC should be the same subnet with the AP, the default IP address of AP is192.168.0.228. Microsoft Internet Explorer 6 updated with Service Pack 1 or the newer patch Q323308.Product Kit Wireless Device×1 Power Module×1 Fixed settings×1 Product CD×1Hardware InstallationTake the following steps to set up the ZA-5000-E (the different of hardware installation betweenZA-5000-E and ZA-5000-I is antenna.).1. All the parts of product are shown as following picture.2. You should fix the Access Point, the following figure shows it.3. Put a Cat-5e STP (Shielded twisted pair) cable with RJ-45 connector through the water-joint.If there no such cable, Make the RJ-45 connector as the following rules:white orange∣orange white green∣blue white blue∣green white brown∣brown