Menu
ZBA ZB-3062 Quick Setup Manual
Also see for ZB-3062: User manual
    | |
Quick Set-up Guide for the ZB-3062 ZBA Inc.11 Regulatory items2 Connecting the scannerRS2321) Disconnect power to the terminal/computer.2) Connect the external power supply (DC adapter) to the serial interface cable of the scanner.3) Plug the serial connector into the serial port on the back of your computer/terminal. Tighten the two screws to secure the connector to the port.4) Plug the power pack into power source.5) Once the scanner has been fully connected, turn the terminal / computer power back on.USB (HID)1) Connect the USB cable between scanner and PC.2) Windows will automatically detect the USB device.USB (Virtual-COM)1) Install driver, USB Serial Emulation Driver, from CD-ROM, The driver will use the next available COM port number2) Connect the USB cable between scanner and PC.3) Windows will automatically detect the USB device.Note: If any of the above operation is incorrect, turn off the power immediately and check any improper connections. Go through all above steps again.3 Interface SelectionThis decoder built-in scanner comes in one model and supports interfaces such as RS232 serial, USB virtual COM and USB HID. In most ofthe cases, simply selecting an appropriate cable and configure the proper interface by following interface selection.Interface selection: You can change factory interface default (USB Virtual COM ) for other type interface. By plugging different cables,setting right interface, then scan the interface barcode, power cycle the scanner will be changed to another interface. However, you mustmake sure which cable you need.RS-232 InterfaceUSB HID (PC)USB HID (MAC)*USB Virtual COM4 Aiming the ScannerThe engine has a view finder that projects a bright red or green aiming beam that corresponds to the engine’s horizontal field of view. The aiming beamshould be centered over the bar code, but it can be positioned in any direction for a good read.The aiming beam is smaller when the engine is closer to thecode and larger when it is farther from the code. Symbologieswith smaller bars or elements (mil size) should be read closerto the unit. Symbologies with larger bars or elements (milsize) should be read farther from the unit. To read single ormultiple symbols Linear bar code 2D Matrix symbol (on apage or on an object), hold the engine at an appropriatedistance from the target, send a trigger command, and centerthe aiming beam on the symbol. If the code being scanned ishighly reflective (e.g., laminated), it may be necessary to tiltthe code +5° to prevent unwanted reflection.FCC: This device complies with Part 15 of the FCC Rules, (1)This device may not cause harmful interface, and (2) This devicemust accept any interface received, including interface that maycause undesirable operation.BSMI : This device is compliant with requirement of BSMI andgranted ID No. R3A078CE: This product conforms to the following standardsEMC:EN55022:2006+A1:2007, class BEN55024:1998+A1:2001+A2:2003This device is compliant with the requirements of theEuropean Union Restriction on the use of HazardousSubstances (RoHS) Directive, 2002/95/EC. |
Related manuals for ZBA ZB-3062
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved