OneStart

Menu

ZBA Z-1070 User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Contents
  1. Table Of Contents
  2. General Information
  3. Optional Accessory
  4. Device Outline
  5. Bluetooth® Communication
  6. Connection Mode
  7. Connect/Disconnect with Target Devices
  8. Packet Example
  9. Use Bluetooth® Dongle
  10. Pairing and Connect to a SPP Slave PDC
  11. Getting Started
  12. Power On Device to Collect Data
  13. Power On Device
  14. Scan Barcode
  15. Keying in Data
  16. Upload Data With Windows Software
  17. Beep Volume
  18. RF Device – PDC as Slave
  19. USB HID Cable
  20. Auto Power off
  21. User Reset
  22. Cleaning the Window and Housing
ZBA Z-1070 User Manual Manual pdf 10 page image
ZBA Inc .Page 10 of 331.5.8. Packet Example:If a record data is "ABCD" with STX/ETX, SEQ and CKS enable, assume SEQ is‘0’ (030H) the send out data is format as:02H + 030H + "ABCD "+ 03AH + 03H030H + 041H (A) + 042H (B) + 043H (C) + 044H (D) = 013AHChecksum = 013AH – 080H= 0BAH Å Still greater than 07FH so repeatChecksum = 0BAH – 080H= 03AHThe Checksum is calculated by adding all data bytes in the packet exceptSTX and ETX. If the result is over 07FH (ASCII extend) subtract the result by080H, if the result is less than 020H (ASCII control code) add 020H to theresult. This will make sure that the checksum will be in the range of visuallyrecognizable ASCII characters.1.5.8 ACK/NAK Control1.5.9. Connection Lost:If during the communication period there is an extended time where there is noresponse, the PDC assumes that the connection is lost as would be the case fora TIMEOUT. The PDC will display “Connection Lost”.Ti view the full instructions for Bluetooth® operation, please refer toDevice Setup, Communication.
/ 33
This manual is suitable for:
Z-1070
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved