Menu
Yukon 26011 Manual
     | |
WARNINGS AND PRECAUTIONSYour NVRS night vision scope was designed to provide many years of reliable service. To ensurethat you get the most enjoyment out of your NVRS, always obey the following Warnings andPrecautions:Do not point the NVRS towards any light source greater than 1 lux (such as car headlights) if theunit has been activated or if the eyepiece shows a green glow. Turn the unit off and wait until thegreen glow dissipates before removing the lens cap.Do not open the case of the NVRS or otherwise attempt to service this device.Clean optical parts (lenses) with professional lens-cleaning supplies designed for use withmulticoated optics.BATTERY INSTALLATIONTo install the two AA batteries, unscrew the battery compartment cover. Slide in the batteriesaccording to +/- polarity indicated on the cover. Tighten the battery compartment cover (1).OPERATIONYour NVRS scope operates using two AA batteries.Make sure they have been installed according to instructions listedin the Battery Installation section.• Move into a dark area before powering on the device. You can also try your scope indaylight with the lens cover on.• Remove the lens cap (2) only when the scope is in the dark.• Activate the device by turning the power switch (3) down to the first click (ON position).• When additional illumination is needed, activate the IR illuminator by turning the powerswitch (3) until second click (IR position).• To illuminate the reticle, turn the switch (4) clockwise and adjust the reticle brightness byrotating the switch clockwise or counterclockwise.• To focus the scope, select an object approximately 100 yds. away and rotate the eyepiecelens (5) until the image is clear.• The green LED indicates that the scope is on. The “ON” LED turns red when the batterystarts discharging.• The night vision riflescope NVRS can be attached on any rifle equipped with a bar for sideor top mounting by use of a Weaver mount (6). The scope is produced with different mountmodifications.• The unauthorized replacement or assembly of the mounts is not allowed. |
Related manuals for Yukon 26011
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved