OneStart

Menu

Ysoft BE3D DEERED User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Safety Precautions
  5. Overview
  6. Safety Components
  7. Accessories
  8. Material Description and Selection
  9. Printer Setup
  10. Working with the Printer
  11. Working with the Printer Touchscreen – Assigning Print Jobs
  12. Removing and Inserting the Filament
  13. Preparing the Print Bed
  14. Printing
  15. Selecting the Print Job
  16. User Servicing and Maintenance
  17. Replacing the Nozzle
  18. Replacing the Print Head
  19. Replacing the Tubing
  20. Replacing the Glass Print Bed
  21. Refi lling the Lubricant
  22. Replacing the Fuses
  23. Resetting the Circuit Breakers
  24. Connecting Peripherals
  25. Periodic proactive maintenance
  26. Removing Supports
  27. Support
  28. Not Covered by the Warranty
  29. Contact Us
Ysoft BE3D DEERED User Manual Manual pdf 28 page image
3. Regularly check the amount of waste in the wastebasket placed in the printer’sstorage area. If the basket starts filling up, remove it and empty it. Do not forgetto return it to its place so that any waste produced by the printer will not fallinto the general storage area.Attention:Always turn the printer off before carrying out any type of hardware usermaintenance.9.2 Replacing the NozzleIf the printer is unable to push the molten filament evenly and continuously throughthe nozzle, the nozzle must be replaced. First of all, carry out the following steps:1. Use the screen of the printer (see chapter 7.4, “Working with the PrinterTouchscreen – Replacing the Filament”, page 19) to remove both filaments fromthe printer.2. Select the “Service Position” button in the “Settings” menu and hold it until amessage asks you to turn the printer off.3. Disconnect the tubing from the print head. Press the plastic ring on the mouthof the print head and, at the same time, pull the tubing out. Repeat the processfor each individual tube.4. If the nozzle is hot, wait for it to cool down.5. Using a small knife or another sharp object, remove the silicon gasket from thenozzle.6. Remove the nozzle using the “be3D tool” wrench.7. Insert the screw of the “be3D tool” into the opening where the nozzle had beenplaced and screw it in.DEERED — USER MANUAL 28
/ 44
This manual is suitable for:
BE3D DEERED
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved