Panning Input Channels 95DM2000 Version 2—Owner’s ManualPanning Input ChannelsInput Channels can be panned between the left and right channels of the Stereo Out.Using the Encoders1 Use the LAYER buttons to select the Input Channel Layers.2 Press the ENCODER MODE [PAN] button to select the Pan Encodermode.3 Use the Encoders to pan the input channels.Using the SELECTED CHANNEL PAN/SURROUND Controls1 Use the LAYER buttons to select the Input Channel Layers, and use the [SEL]buttons to select the Input Channels.2 Use the Pan control to pan the currently selected Input Channel.The pan display indicates the pan position of the currently selected Input Channel. Whenpan is set to center, the center two segments light up. You can use the [L] and [R] buttonsto select horizontal or vertical Input Channel partners.The [LINK] button, which is enabled only when a Surround mode other than Stereo isselected, is used to link the Pan control and the Joystick so that either control can be usedfor panning. This setting applies only to Input Channels that are currently selected. For thisto work, the [EFFECT] button indicator must be off and the [GRAB] and [LINK] buttonindicators must be on.LINK GRAB EFFECTLEVENRL RPAN / SURROUNDDISPLAY ODD
