Yamaha UB2115 Owner's Manual

31.24012.0008.0004.0005.000.402 12X.500 3X8.00016.00024.0001.500 12X4.2508.50030.500.75016.12031.0001.402.265.402 4X14.50012.5006.5001.7505.000Thank you for choosing this Yamaha product.Please read this manual carefully before using it in a speaker installation.Keep the manual in safe place for future reference.Installation Instructions1. Remove the speaker's center side screws.If you are using speaker model IF2115/AS(W) install thesocket cover bracket to the speaker using the M10 buttonhead screws.2. Place the U-bracket over the speaker cabinet and confirmthat you have ordered the correct bracket. Temporarily insertthe sound isolation gaskets between the arms of the bracketand the speaker. Remove the bracket from speaker.3. Select the area where the speaker will be mounted. Makesure the mounting surface is structurally adequate forsupporting the weight of the speaker.Do not attempt to install to drywall, acoustic tiles, etc.4. Attach the base of the U-bracket to the wall or ceiling usingthe appropriate hardware. Tighten the hardwarepermanently.The appropriate hardware and bolts for this step are notincluded in this package. If in doubt as to what hardware touse, consult a hardware specialist.When attaching the U-bracket to a wall or other vertical structure, DONOT position the bracket vertically. Make sure to install the brackethorizontally.5. Rosition the speaker in between the bracket arms with thesound isolation gaskets. (Use one each of the 1/4" and 1/8"gaskets on one side and one 1/4" gasket on the other side.)Secure the speaker to the bracket using the includedhardware through the desired slots into the speakerenclosure's threaded mounting holes.If you are installing the socket cover to the speaker, use oneeach of the 1/4" and 1/8" gaskets on one side and one 1/8"gasket and the socket cover on other side.6. Rotate the speaker to the desired direction then fully securethe side bolts.Secure the speaker to the mounting structure with a properly rated safetycable.CAUTIONCAUTIONUB2115(W)U BRACKETNOTEPackage ContentsUB2115(W)❒ U-mount bracket (1 pc.)❒ M10-40mm button head socket screws (4 pcs.)❒ Friction gaskets, 1/4" thick (2 pcs.)❒ Friction gaskets, 1/8" thick (2 pcs.)❒ Washers, M10 diameter (2 pcs.)❒ Split lock washers, M10 (2 pcs.)❒ Socket cover bracket (1 pc.)❒ Wrench, hex L-key, M10 (1 pc.)Owner’s ManualEN PRECAUTIONSAlways follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the deviceor other property. These precautions include, but are not limited to, the following:• Before doing any installation or construction work, consult with an installation expert.• Make sure that the surface this bracket is being mounted on has the strength to handle the weight of both the speaker and thisbracket.• Use bolts and nuts as well as washers for installation and tighten them firmly so that the speaker is secure and does not move.• Always loosen the corresponding screw before adjusting the angle or direction of the speaker. Never force this adjustment withthe screw still tightened.• Some fittings may deteriorate over extended periods of time due to wear and/or corrosion. For optimum safety, the installationshould be checked thoroughly at regular intervals.Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure orimproper installation.* Illustrations herein are for explanatory purposes only, and may not match actual appearance during operation.* Company names and product names herein are trademarks or registered trademarks of their respective companies.* Specifications and descriptions in this owner's manual are for information purposes only. Yamaha Corp. reserves the right tochange or modify products or specifications at any time without prior notice. Since specifications, equipment or options maynot be the same in every locale, please check with your Yamaha dealer.CAUTIONPLEASE READ CAREFULLY BEFORE PROCEEDING* Please keep this manual in a safe place for future reference.CAUTION When attaching the U-bracket to a wall or other verticalstructure, DO NOT position the bracket vertically.Make sure to install the bracket horizontally.Dimensions

/ 1

Related manuals for Yamaha UB2115